Sensitive surfaces of high-end materials such as sheet metals from stainless steel or also plexiglass are protected by the suppliers with protective foils. The removal of these foils is often time-consuming and difficult, because a little edge of the foil must be found for lifting, in most cases this is done by scratching with the fingernail.
As a solution for this problem, DOSCORNIO SPECIAL TOOLS has developed a practical tool: the PULLWORKER. In rubbing with the PULLWORKER from one edge in the direction where the foil shall be detached, the foil is separated from the base material. Once a part of the foil is lifted this way, the foil can be fixed between the fingers and be pulled off then.
The unique grip of the PULLWORKER is a result of a special formulation using natural rubber.
Protective foils can be cut on metal surfaces with the integrated cutting tool.
It is recommended to clamp the workpiece in a bankmaster® vacuum workplace system. Using the bankmaster® vacuum clamping system the workpiece may be fixed and relased very fast without any surface damage.
More information: www.pullworker.com
DOSCORNIO SPECIAL TOOLS
Pieter van Weenen & Co. GmbH
Fabrik Sonntag 3
79183 Waldkirch
info@doscornio.com
Phone: +49 (0) 7681 24 100
As a solution for this problem, DOSCORNIO SPECIAL TOOLS has developed a practical tool: the PULLWORKER. In rubbing with the PULLWORKER from one edge in the direction where the foil shall be detached, the foil is separated from the base material. Once a part of the foil is lifted this way, the foil can be fixed between the fingers and be pulled off then.
The unique grip of the PULLWORKER is a result of a special formulation using natural rubber.
Protective foils can be cut on metal surfaces with the integrated cutting tool.
It is recommended to clamp the workpiece in a bankmaster® vacuum workplace system. Using the bankmaster® vacuum clamping system the workpiece may be fixed and relased very fast without any surface damage.
More information: www.pullworker.com
DOSCORNIO SPECIAL TOOLS
Pieter van Weenen & Co. GmbH
Fabrik Sonntag 3
79183 Waldkirch
info@doscornio.com
Phone: +49 (0) 7681 24 100
